Flip-up Glass Release Switch - Installation

INSTALLATION





1. From the bottom of the handle and light bar housing (4), engage the retaining tab (3) on the left end of the liftgate flip-up glass latch release switch (1) into the inboard side of the mounting hole.
2. Push the right end of the switch housing up into the outboard end of the mounting hole far enough for the latch feature (5) to snap into place.
3. Working from the inside of the handle and light bar housing, reconnect the handle and light bar wire harness connector (2) to the connector receptacle of the switch.
4. Reinstall the handle and light bar unit onto the outside of the liftgate. Exterior Handle Lamp Bar- Installation.
5. Reconnect the battery negative cable.