Air Suspension Hose Assembly - Installation

INSTALLATION

WARNING: All pressurized air suspension components contain high pressure air (up to 220 psig). Use extreme caution when inspecting for leaks. Wear safety goggles and adequate protective clothing when inspecting or servicing the air suspension system. A sudden release of air under this amount of pressure can cause personal injury or death.

WARNING: Support the vehicle by supplemental means before performing any work on the air suspension system to prevent the vehicle from changing height. Before any given component is to be serviced it must be deflated. Servicing the air suspension system without supplemental support, or with pressure in the specific component, can cause personal injury or death.





1. Position the air suspension hose assembly in the vehicle.
2. Attach the OUT hose (5) to the valve block (3) with the spring clamp.





3. Connect the suction hose elbow (4) to the compressor (3) by pushing over the fitting. Pull the elbow (4) to verify it is locked into place.






NOTE: Before and while connecting the retaining clips , verify there is no twists or kinks in the hoses.

4. Connect the filter retaining clip (2) to the body, and the hoses (3) to the routing clips (4).

5. Install the RF wheel splash shield Splash Shield - Installation.
6. Install the RF tire and wheel Service and Repair.
7. Remove the support and lower the vehicle.