Air Suspension Temperature Sensor - Installation

INSTALLATION

WARNING: All pressurized air suspension components contain high pressure air (up to 220 psig). Use extreme caution when inspecting for leaks. Wear safety goggles and adequate protective clothing when inspecting or servicing the air suspension system. A sudden release of air under this amount of pressure can cause personal injury or death.

WARNING: Support the vehicle by supplemental means before performing any work on the air suspension system to prevent the vehicle from changing height. Before any given component is to be serviced it must be deflated. Servicing the air suspension system without supplemental support, or with pressure in the specific component, can cause personal injury or death.





1. Install the push nut for the retaining screw from the bracket (not shown).
2. Position the air suspension temperature sensor (3), install the retainer screw (6) and tighten to 4 Nm (36 in. lbs.).
3. Connect the air suspension temperature sensor wiring harness electrical connector (5).
4. Install the fog lamp trim bezel to the fascia.
5. Install the RF fog lamp Fog Lamp - Installation.
6. Install the RF wheel splash shield Splash Shield - Installation.
7. Install the RF tire and wheel Service and Repair.
8. Perform the ASCM Verification Test ASCM Verification Test.