Air Suspension Temperature Sensor - Removal

REMOVAL

WARNING: All pressurized air suspension components contain high pressure air (up to 220 psig). Use extreme caution when inspecting for leaks. Wear safety goggles and adequate protective clothing when inspecting or servicing the air suspension system. A sudden release of air under this amount of pressure can cause personal injury or death.

WARNING: Support the vehicle by supplemental means before performing any work on the air suspension system to prevent the vehicle from changing height. Before any given component is to be serviced it must be deflated. Servicing the air suspension system without supplemental support, or with pressure in the specific component, can cause personal injury or death.






NOTE: Fascia removed for clarity.

1. Raise and support the vehicle Maintenance.
2. Remove the RF tire and wheel.
3. Remove the RF wheel splash shield Splash Shield - Removal.
4. Remove the RF fog lamp Fog Lamp - Removal.
5. Remove the fog lamp trim bezel from the fascia for access.
6. Disconnect the air suspension temperature sensor wiring harness electrical connector (5).
7. Remove the air suspension temperature sensor retaining screw (6) and remove the sensor (3).
8. Remove the push nut for the retaining screw from the bracket (not shown).