Rear Door Glass - Installation

INSTALLATION





1. Carefully lower the door glass (1) into the rear door through the window opening.






NOTE: Illustration shown with inner door panel removed for clarity.

2. Position the door glass (2) between the rear glass run channel (1) and the inner door panel.
3. Rotate the door glass (2) into position toward the front of the vehicle.
4. Slide the door glass in the track to insure proper alignment and then position the glass into the full up position and secure.





5. Install the carrier plate assembly. Rear Door Carrier Plate - Installation
6. Lower the glass and seat into the regulator glass slider. Grasp the glass along the top edge and make sure the glass is seated and secured fully.
7. Position and seat the inner belt molding fully.
8. Install the upper trim molding.
9. Connect the negative battery cable.