Vehicles Built After 1/12/2011

VEHICLES BUILT AFTER 1/12/2011





1. Disconnect and isolate the negative battery cable.
2. Remove the upper trim molding.

NOTE: There are foam seals at either end that is held in place by the inner belt molding. Carefully remove the seals along with the inner belt molding.

3. Separate the inner belt molding from the door mounting flange from the back to the front.





4. If necessary, temporarily connect the window switch assembly and battery to actuate the motor.
5. Remove the plug (2).
6. Using the regulator, move the door glass (1) up or down as required to access the window regulator glass release tab through the access holes in the regulator rail.






NOTE: Place a protective covering over the outer belt molding to prevent grease transfer to the molding and glass.

7. Using a small round bladed tool (3) or equivalent, release the door glass (1) from the window regulator glass slider (2).
8. Position the glass in the full up position and secure the glass.





9. Remove the carrier plate assemble (1). Rear Door Carrier Plate - Removal






NOTE: Illustration shown with inner door panel removed for clarity.

10. Position the door glass (2) between the rear glass run channel (1) and the inner door panel.
11. Carefully rotate the door glass (2) towards the rear of the vehicle within the window opening.





12. Remove the glass (1) from the door, through the window opening.