B1A3E

B1A3E-SIREN / ITM MISMATCH





For a complete wiring diagram, refer to the Wiring Information.


- When Monitored:
While the Vehicle Theft and Security System (VTSS) is armed.

- Set Condition:
When the learned Siren information stored in the Intrusion Transceiver Module (ITM) does not match.





1. DETERMINING IF DIAGNOSTIC TROUBLE CODE (DTC) IS CURRENT

NOTE: Diagnose any related Communication DTCs before continuing.

1. With a scan tool, read and record DTCs.
2. With the scan tool, clear DTCs.
3. Turn the ignition off and remove the key from the ignition.
4. Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute.
5. Disarm the VTSS.
6. Using the scan tool, read DTCs.

Does the DTC reset?

Yes

- Inspect wiring from ITM to Siren for an intermittent open condition. Check connector terminals for back out, corrosion or loose terminal contact. If OK, Replace the Siren.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 2

2. INTERMITTENT CONDITION

NOTE: Check for any of the follow conditions:
- Poor wire to terminal connection
- Corroded terminals
- Backed out or loose terminals
- Broken wire internal to the insulation

Were there any problems found?

Yes

- Repair the wiring as necessary.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.