Side Marker Lamp - Installation

LAMP

NOTE: The following procedure applies only to vehicles manufactured for domestic markets. Vehicles manufactured for export markets do not have a bulb, socket or wiring provided to illuminate the front side marker compartment of the front lamp unit. The front side marker for export vehicles is replaced by a white reflector.





1. From the outer surface of the front fascia engage the tab at the top of the front side marker lamp housing into the notch of the outboard-facing end of the fascia, then insert the stud on the bottom of the housing into the mounting hole.
2. Install and tighten the nut (3) that secures the stud near the bottom of the lamp housing (1) to the inside surface of the front fascia (2). Tighten the nut securely.
3. Reconnect the wire harness connector (3) to the connector receptacle integral to the bulb socket.
4. Reinstall the liner to the front of the front fender wheel house. Splash Shield - Installation.
5. Reconnect the battery negative cable.