B1094

B1094-FRONT LEFT SEAT HEATER CONTROL CIRCUIT OPEN





For a complete wiring diagram, refer to the wiring information .

- When Monitored:
Ignition on, during heated seat operation.

- Set Condition:
The Heated Seat Module (HSM) detects an open or high voltage condition.





1. CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, clear all DTCs.
3. Operate the Heated Seat Switch in both positions several times.

NOTE: Check connectors - Clean and repair as necessary.

4. With the scan tool, read DTCs.

Does the scan tool display this DTC as active?

Yes

- Go To 2

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform BODY VERIFICATION TEST. Body Verification Test.

2. (P187) LEFT FRONT SEAT HEATER CONTROL CIRCUIT SHORTED TO VOLTAGE




1. Disconnect the Heated Seat Module harness connector.
2. Turn the ignition on.
3. Measure the voltage on the (P187) Left Front Seat Heater Control circuit.

Is there voltage above 0.5 volts?

Yes

- Repair the (P187) Left Front Seat Heater Control circuit for a short to voltage.
- Perform BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 3

3. (P187) LEFT FRONT SEAT HEATER CONTROL CIRCUIT OPEN




1. Turn the ignition off.
2. Measure the resistance of the (P187) Left Front Seat Heater Control circuit at the Heated Seat Module harness connector to chassis ground.

Is the resistance between 2 and 5 Ohms?

Yes

- Replace the Heated Seat Module.
- Perform BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 4

4. (Z912) SEAT HEATER GROUND CIRCUIT OPEN
1. Measure the resistance between ground and the (Z912) Seat Heater Ground circuit.

Is the resistance above 5.0 Ohms?

Yes

- Repair the open or excessive resistance in the (Z912) Seat Heater ground circuit.
- Perform BODY VERIFICATION TEST. Body Verification Test.

No

- Check the heater wiring in the driver seat harness for an open, if OK replace the open seat heater element(s).
- Perform BODY VERIFICATION TEST. Body Verification Test.