B10BC

B10BC-RIGHT HEATED SEAT SWITCH INPUT CIRCUIT STUCK

For a complete wiring diagram, refer to the wiring information .

- When Monitored:
With the ignition on.

- Set Condition:
If the Cluster (CCN) senses the Right Heated Seat switch input for more than 20 seconds.





CHECK FOR AN ACTIVE DTC

NOTE: Diagnose and repair all LIN Bus related DTCs before performing this test procedure.

1. Turn the ignition on.
2. Inspect the Right Heated Seat switch for anything that would cause it to stay or stick in a pushed position.
3. Press and release the Right Heated Seat switch several times and then wait 20 seconds.
4. With a scan tool, read DTCs.

Does the scan tool display this DTC as active?

Yes

- Replace the Switch Bank.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.