Intrusion Transceiver Module (ITM)

U1415-00-IMPLAUSIBLE/MISSING VEHICLE CONFIGURATION DATA

For a complete wiring diagram, refer to the wiring information .

- When Monitored:
Continuously with the ignition on.

- Set Condition:
The Intrusion Transceiver Module (ITM) receives incorrect vehicle configuration information from the Totally Integrated Power Module (TIPM).





1. CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read DTCs.

Does the scan tool display this DTC as active?

Yes

- Go To 2

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. CAN BUS DTCS SET IN TOTALLY INTEGRATED POWER MODULE (TIPM)

NOTE: Verify that the TIPM has the correct vehicle configuration before proceeding with this test step.

1. With the scan tool, read DTCs in the TIPM.

Are there any active CAN Bus DTCs present?

Yes

- Testing and Inspection Perform the appropriate diagnostic procedure.

No

- Replace the ITM.
- Perform the BODY VERIFICATION TEST. Body Verification Test.