Side Repeater Lamp Bulb - Installation

BULB

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.

NOTE: The front side marker lamps are used only on vehicles manufactured for domestic markets, while repeater lamps are used only on vehicles manufactured for export markets. The service procedures for the bulbs of these two unique lamps are the same.





1. Reach between the front wheel flare (3) and the front tire above the front bumper (2) to access the back of the lamp (1).
2. Align the base of the bulb with the lamp socket (4).
3. Push the bulb straight into the socket until the base is firmly seated.
4. Align the socket and bulb with the keyed opening on the back of the lamp.
5. Insert the socket and bulb into the housing until the socket is firmly seated.
6. Rotate the socket clockwise about 30 degrees to lock it into place.
7. Reconnect the battery negative cable.