Clutch: Service and Repair

BLEED CLUTCH HYDRAULIC CIRCUIT

Special Tools:






Use Mopar brake fluid, or an equivalent quality fluid meeting SAE J1703-F and DOT 3 standards only. Use fresh, clean fluid from a sealed container at all times.

Do not allow the master cylinder to run out of fluid during bleed operations. An empty cylinder will allow additional air to be drawn into the system. Check the cylinder fluid level frequently and add fluid as needed.

BLEED CLUTCH HYDRAULIC CIRCUIT





1. Verify fluid level in brake master cylinder, top off brake fluid as necessary.

NOTE: Pre filling a new slave cylinder will reduce bleeding time required.

2. Install a length of clear hose to divert fluid into suitable container.
3. Push and hold clutch pedal down, open bleeder (1) on slave cylinder (2), allow fluid to bleed out, then close bleeder. Repeat this step several times until no air is observed coming out of the bleeder.
4. Remove drain hose and replace dust cap on bleeder and install slave cylinder on transmission.
5. Actuate clutch pedal 25 times, then start engine and verify clutch operation and pedal feel.If pedal feels spongy or clutch does not fully disengage, air is still trapped in the hydraulic circuit and must be bleed again.

PRESSURE BLEED CLUTCH HYDRAULIC CIRCUIT

Follow manufacturers instructions carefully when using pressure equipment. Do not exceed the tank manufacturers pressure recommendations. Generally, a tank pressure of 15-20 psi is sufficient for bleeding.

Fill bleeder tank with recommended DOT 3 fluid and purge air from the tank lines before bleeding.

Do not pressure bleed without a proper master cylinder adapter. The wrong adapter can lead to leakage, or drawing air back into the system. Use adapter provided with the equipment or Adapter.