Power Window Switch - Removal

REMOVAL

Special Tools:






WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, Occupant Classification System (OCS), seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to follow these instructions may result in accidental airbag deployment.

FRONT





1. Disconnect and isolate the negative battery cable.
2. Using trim stick () or a suitable flat bladed tool, gently pry the switch assembly (2) away from the instrument cluster bezel (1).
3. Disconnect the switch assembly electrical connector and remove the switch.

REAR





1. Disconnect and isolate the battery negative cable.
2. Using trim stick (), gently pry the console back panel away from the console.
3. Remove the center console assemble's rear panel (1).
4. Disconnect electrical connectors.
5. Release the integrated latches and remove switch assembly.