Front Seat - Installation

INSTALLATION





1. Position the seat into the vehicle and connect the electrical connectors, if equipped.
2. Install the bolts (2).
3. Tighten the inboard bolt to 41 Nm (30 ft. lbs.).
4. Tighten the outboard bolt to 41 Nm (30 ft. lbs.).
5. Install the fastener trim covers (1).





6. Install the rear bolts (1).
7. Tighten the inboard bolt to 41 Nm (30 ft. lbs.).
8. Tighten the outboard bolt to 41 Nm (30 ft. lbs.).
9. Close the fastener covers (2).





10. Install the seat belt anchor (1) and install the bolt (3).
11. Tighten the bolt (3) to 54 Nm (40 ft. lbs).
12. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed following service of any supplemental restraint system component. Restraints System Verification Test