Installation

INSTALLATION

WARNING: Do not smoke or use open flames/sparks when servicing the fuel system. Wear protective clothing and eye protection. Make sure the area in which the vehicle is being serviced is in a well ventilated area and free of flames/sparks. Failure to comply may result in serious or fatal injury.

CAUTION: The electrical connector (3) on the ESIM switch must be in 3 O'clock position after installation. This step must be done for proper switch operation.





1. A lock tab (see arrow) is used on the back of the switch. Position the ESIM switch into the EVAP canister and rotate switch until the electrical connector is in 3 O'clock position and the locking tab locks into position.





2. Connect the ESIM fresh air hose (1) at the fresh air filter.
3. Connect the electrical connector (2) at the ESIM.





4. Install the left rear wheelhouse splash shield Splash Shield - Installation.
5. Install left rear wheel and tire.





6. Lower the vehicle.
7. Connect the negative battery cable (2).
8. Install the fuel tank filler cap.
9. Start the engine and check for leaks.