Rear

REAR





1. Install the brake pads if removed.
2. Install caliper. Tighten the bolts (6) to 37 Nm (28 ft. lbs.)

CAUTION: Verify brake hose (5) is not twisted or kinked before tightening fitting bolt.

3. Install the brake hose (5) to the caliper with new seal washers and install the brake hose banjo bolt (4) tighten fitting bolt to 31 Nm (23 ft. lbs.).
4. Remove the prop rod from the vehicle.
5. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be performed.Service and Repair.
6. Install the wheel and tire assemblies Service and Repair.
7. Remove the supports and lower the vehicle.
8. Verify a firm pedal before moving the vehicle.