Evaporator Temperature Sensor - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

NOTE: Illustration shown with instrument panel removed for clarity.






NOTE: LHD model shown. RHD model similar.

1. Disconnect and isolate the negative battery cable.
2. Partially remove the instrument panel to gain access to the evaporator temperature sensor (1) located in the rear of the HVAC housing (2), near the bottom of the instrument panel on the passenger side Instrument Panel - Removal.
3. Disconnect the instrument panel wire harness connector from the evaporator temperature sensor and remove the sensor from the HVAC housing.