Air Bag Module (Passenger Side)

AIR BAG MODULE (PASSENGER SIDE)

REMOVAL

WARNING
1. Never attempt to disassemble or repair the airbag module.
2. Do not drop the airbag module or allow contact with water, grease or oil. Replace it if a dent, crack, deformation or rust are detected.
3. The airbag module should be stored on a flat surface and placed so that the pad surface is facing upward. Do not place anything on top of it.
4. Do not expose the airbag module to temperature over 93 °C (200 °F)
5. An undeployed airbag module should only be disposed of in accordance with the procedures contained in this manual.
6. Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious personal injury.
7. Whenever the PAB is deployed, it should be replaced with a new PAB assembled with an extension wire. When the PAB deploys, the squib melts making the extension wire on the deployed airbag module useless.




1. Disconnect the battery negative (-) terminal cable.

WARNING: Wait at least 30 seconds in order to prevent inadvertent airbag deployment.

2. Remove the glove box.
3. Disconnect the PAB module connector.
4. Remove the crash pad assy and then do the PAB module.