Receiver Dryer: Service and Repair

Removal
1. Discharge refrigerant from A/C system. Refer to operating instructions of your refrigerant recovery/recycling/charging station for proper procedures.
2. Disconnect triple pressure switch connector.
3. Disconnect high and low pressure pipes.

NOTE: Immediately plug all open fittings to keep moisture out of system.

4. Remove mounting bolts from receiver/driver.
5. Remove receiver/driver.

Installation
1. Install receiver/drier in the reverse order of removal.
2. Evacuate refrigerant system. Refer to operating instructions of your refrigerant recovery/recycling/charging station for proper procedures.
3. Charge A/C system. Refer to operating instructions of your refrigerant recovery/recycling/charging station for proper procedures.

NOTE:
a. Immediately plug all open fittings to keep moisture out of system.
b. Apply clean compressor oil to O-rings before connecting fittings.
c. Do not apply compressor oil to fittings.
d. When installing new receiver/drier, add compressor oil.

Compressor oil : 0.61 cu in (10 cc)