Monitor DTC Status

P2106 Lime Home Mode

Force Limited Power - Scantool Diagnostics

Monitor Scantool Data

1. Connect GDS to Data Link Connector (DLC).
2. IG "ON" & Monitor that any different DTC (Diagnostic Trouble Code) is existed.
(There will be at least one more DTC which causes this DTC P2106 to retrieve)
3. Repair the DTCs cause DTC P2106 first according to the designated trouble shooting guide.
(After repairing the DTCs cause DTC P2106, don't forget to do "ETC Initialization" as follows.)
4. Is the same DTC occurred?





** Procedure of ETS Initialization
A. Erase the trouble codes on PCM
B. Turn the ignition key off and keep this condition until the main relay is turned off. (It will take 10 sec.)
C. Turn ignition key on more than 1second to record the throttle motor position on the EEPROM