Repair Procedures

Replacement

1. Remove the floor console assembly.

2. Remove the shift cable (A).




3. Remove the retainer (A) by loosening the nut (B-2ea).

Tightening torque:
9.8 - 13.7 N.m (1.0 - 1.4 kgf.m, 7.2 - 10.1 lb-ft)




4. Loosen the nut (C) and then remove the cable (B) from the bracket (A) at transaxle assembly side.

Tightening torque:
9.8 - 13.7 N.m (1.0 - 1.4 kgf.m, 7.2 - 10.1 lb-ft)




5. Remove the shift cable inside of cab.
6. Installation is the reverse of removal.

NOTE:
- When installing, set room side lever and T/M side lever to N position.
- Adjust the shift lock cable after installing.


Adjustment

Adjusting method for T/M shift cable
1. Set room side lever and T/M side lever to N position.
2. Connect the room side lever (A) and shift cable (B).




3. Push cable to "F" direction shown to eliminate FREE PLAY.
4. Tighten adjusting nut (A).

Tightening torque:
9.8 - 13.7 N.m (1.0 - 1.4 kgf.m, 7.2 - 10.1 lb-ft)




5. After adjusting, check to be sure that this part operates as designed at each range of T/M side corresponding to each position of room lever.

Inspection

1. Check the damage and operation of the control cable.
2. Check the damage of the boot.
3. Check the damage and corrosion of the bushing.
4. Check the damage or weakening of the spring.