Fuse Block: Service and Repair

Central Junction Box (CJB)

Service Repair No - 86.70.56

Removal

1. If the central junction box (CJB) is to be replaced, connect T4 to the vehicle.
2. Remove the glove compartment.
3. Remove the passenger side closing trim panel.
^ Release the clip.
^ Remove the 2 screws.
^ Disconnect the electrical connector.





4. Remove the CJB.
^ Remove the 2 nuts.
^ Disconnect the 6 electrical connectors.





Installation

1. Install the CJB.
^ Connect the electrical connectors.
^ Tighten the nuts to 10 Nm (7 lb.ft).
2. Install the closing trim panel.
^ Connect the electrical connector.
^ Secure the clip.
3. Install the glove compartment.
4. Initiate a new CJB using T4.