Navigation Display: Service and Repair

Navigation System Display Module
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal










Torque to: 2.5 Nm









NOTE:
LHD illustration shown, RHD is similar.

















Torque to: 2.5 Nm





NOTE:
Do not disassemble further if the component is removed for access only.

Installation
1 To install, reverse the removal procedure.
2 If a new component has been installed, configure using Land Rover approved diagnostic equipment.