Blower Motor: Service and Repair

Blower Motor

Removal
1 Remove the glove compartment. For additional information, refer to Glove Compartment




2 Remove the passenger side closing trim panel.
- Release the clip.
- Remove the 2 screws.
- Disconnect the electrical connector.




3 Position the footwell duct aside for access.
- Release the clip.
4 Remove the blower motor.
- Disconnect the electrical connector.
- Remove the 3 screws.

Installation
1
CAUTION: Fixings must be started by hand to avoid damaging threads.
Install the blower motor.
- Tighten the screws.
- Connect the electrical connector.
2 Secure the footwell duct.
- Install the clip.
3 Install the closing trim panel.
- Connect the electrical connector.
- Secure the clip.
- Tighten the screws.
4 Install the glove compartment. For additional information, refer to Glove Compartment