Replacement
REPLACEMENT1. PRECAUTION
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
4. DISCONNECT PASSENGER AIRBAG CONNECTOR
a. Remove the glove compartment door sub-assy.
b. Remove the glove compartment door pad plate from the instrument panel finish panel lower No.2.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
c. Using a screwdriver, slide the airbag connector to pull out from the glove compartment door pad plate.
d. Disconnect the airbag connector.
5. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSY
6. REMOVE INSTR PNL PASS L/DOOR AIR BAG ASSY
a. Remove the 2 screws.
b. Release the rear side wall of the airbag door from the hook by slightly deflecting it and roll the instr pnl pass L/door airbag assy forward.
c. Release the front side wall of the airbag door from the other hook and remove the instr pnl pass L/door airbag assy.
7. INSPECT INSTR PNL PASS L/DOOR AIR BAG ASSY
8. INSTALL INSTR PNL PASS L/DOOR AIR BAG ASSY
9. CENTER SPIRAL CABLE
10. INSTALL STEERING WHEEL ASSY
11. INSPECT STEERING WHEEL CENTER POINT
12. INSTALL HORN BUTTON ASSY
13. INSPECT HORN BUTTON ASSY
14. INSPECT SRS WARNING LIGHT