Toe-In

Fig. 4 Tie Rod End Adjusting Location:

Front
1. Remove boot clips.
2. Loosen tie rod end locknut.
3. Turn left and right tie rod ends an equal amount to adjust toe-in. Ensure lengths of the tie rod ends remain the same, Fig. 4.
4. Torque tie rod end locknuts to 41 ft. lbs.
5. Place boot on the seat and clamp it. Ensure boots are not twisted.

Fig. 5 Rear Toe-in Adjustment Rods:

Fig. 6 Rear Toe-in Adjustment Cam:

Rear
For the following procedure, refer to Figs. 5 and 6. If the toe-in is out of the standard toward toe-in side, lengthen the shorter arm by the cam. If the toe-in is out of the standard toward toe-in side, shorten the longer arm by the cam. If the left-right error is within the specifications but the overall toe-in is not, lengthen or shorten both arms an equal amount each by turning the two cams in the opposite direction until the adjustment standard is obtained.