Final Assembly

FINAL ASSEMBLY

Figure 7:

1. Align the front of the running board so that it is level and flush with the front flare. The running board should be parallel to the vehicle and the rear end cap should line up with the fender extension. The gap between the bottom of the rear door extension and the top of the rear end cap should be a maximum of 1/2 inch (see figure 7).

2. After the running board has been aligned, tighten all brackets to the running board platform with the provided M-8 nut and bolt assemblies. Torque to 12 ft. lbs.

3. From underneath the running board, slide the front end plate against the front flare tab. When the tab is against the plate, tighten the M-8 nut to the running board with 12 ft. lbs. Then attach the tab with the provided M-8 bolt and nut and tighten to 12 ft. lbs. (refer to figure 6).

4. Slide the rear end cap towards the lip of the door extension until it is approximately 1/4 inch away. Tighten the end plate to the running board with 12 ft. lbs. Press the front of the end cap firmly against the front of the running board and tighten the M-8 nuts on the studs of the end cap to 6 ft. lbs. (see figure 7).

5. Open and close the rear door t6 confirm that there is no interference between the rear end cap and the rear door extension. If there is interference, insure that the running board is parallel to the vehicle and/or readjust the rear end cap.

6. Repeat the procedure for the other side of the vehicle.