Steering Column: Testing and Inspection

Tilt Steering Column (1 Of 2):

Tilt Steering Column (2 Of 2):

INSPECTION
1. Inspect steering lock operation. Check that the steering lock mechanism operates properly.
2. If necessary, replace key cylinder.
a. Place the ignition key at the ACC position.





b. Push down the stop pin with a screwdriver, and pull out the cylinder.
c. Install a new cylinder.

HINT: Make sure the key is at the ACC position.

3. Inspect ignition switch.
4. Inspect key unlock warning switch.
5. If necessary, replace ignition switch with key unlock warning switch.
a. Remove the 2 screws.
b. Install a new switches with the 2 screws.

6. Inspect key interlock solenoid.





7. If necessary, replace key interlock solenoid.
a. Remove the 2 screws.
b. Remove the solenoid, spring and lock pin.
c. Install a new solenoid with the spring and lock pin, with the 2 screws.





8. If necessary, replace bushing.
a. Using a screwdriver, remove the bushing from the column lower tube.
b. Coat a new bushing with molybdenum disulfide lithium base grease.
c. Align the holes of the tube and projections of the bushing.