Fuel Pump Ballast Resistor: Testing and Inspection

1. REMOVE FUEL PUMP RESISTOR
(a) Disconnect the fuel pump resistor connector.
(b) Remove the bolt and fuel pump resistor.





2. INSPECT FUEL PUMP RESISTOR
Using an ohmmeter, measure the resistance between the terminals.

Resistance: At 20°C (68°F) 0.70 - 0.76 ohm

If the resistance is not as specified, replace the resistor.
3. REINSTALL FUEL PUMP RESISTOR

Torque: 18 N.m (185 kgf.cm, 13 ft.lbf)