Rear

TIGHTENING SPECIFICATIONS
4 Bearing Cap Bolts:
w/ Differential Lock 113 Nm (83 ft. lbs.)
w/o Differential Lock 78 Nm (58 ft. lbs.)
4 Dog Clutch/Case Bolts 24 Nm (17 ft. lbs.)
Actuator Shift Fork Shaft Set Bolt 20 Nm (14 ft. lbs.)
Adjusting Nut Locks 13 Nm (9 ft. lbs.)
Case And Cover [1] 58 Nm (43 ft. lbs.)
Indicator Switch 40 Nm (30 ft. lbs.)
Pinion Shaft Pin/Washer 27 Nm (20 ft. lbs.)
Pinion Nut (Max. For Preload) 441 Nm (326 ft. lbs.)
Ring Gear/Case Set Bolts 110 Nm (81 ft. lbs.)

[1]: 5 bolts and 3 pinion shaft pins.

SERVICE SPECIFICATIONS
Drive Pinion Preload (At Starting):
1st Pass (Initial):
New Bearing 1.3 - 2.0 Nm (11.3 - 17.4 inch lbs.)
Reused Bearing 0.7 - 1.0 Nm (6.1 - 8.7 inch lbs.)
2nd Pass (After Side Bearing Preload):
w/o Differential Lock 0.4 - 0.6 Nm (3.5 - 5.2 inch lbs.)
w/ Differential Lock 0.3 - 0.7 Nm (2.6 - 6.1 inch lbs.)
3rd Pass (Bearing Spacer Check):
New Bearing 1.3 - 2.0 Nm (11.3 - 17.4 inch lbs.)
Reused Bearing 0.7 - 1.0 Nm (6.1 - 8.7 inch lbs.)
Ring Gear:
Backlash 0.15 - 0.20 mm (0.0059 - 0.0079 inch)
Runout 0.10 mm (0.0039 inch)
Side Gear Backlash 0.02 - 0.20 mm (0.0008 - 0.0079 inch)