With OBD II Scan Tool

1. Prepare the OBD II scan tool(complying with SAE J1978).
2. Connect the OBD II scan tool to DLC3 in the fuse box at the lower left of the instrument panel.
3. Turn the ignition switch ON and switch the OBD II scan tool main switch ON.
4. Use the OBD II scan tool to check the DTCs and freeze frame data, note them down. (For operating instructions, see the OBD II scan tool's instruction book.)

NOTICE: When simulating symptoms with an OBD II scan tool (excluding LEXUS hand-held tester) to check the DTCs, use normal mode. For codes on the DTC chart subject to "2 trip detection logic", turn the ignition switch OFF after the symptom is simulated the first time. Then repeat the simulation process again. When the problem has been simulated twice, the MIL lights up and the DTCs are recorded in the ECM.