Installation

NOTE:
- Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
- Never reuse the airbag sensor assembly involved in a collision when the airbag has deployed.
- Never repair a sensor in order to reuse it.







1. INSTALL AIRBAG SENSOR ASSEMBLY
a. Using a torx wrench, install the airbag sensor assembly with 3 screws.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)

Torque: 20 N.m (200 kgf.cm, 15 ft.lbf)

b. Connect the airbag sensor connectors.

NOTE:
- Connection of the connector is done after the sensor assembly has been installed.
- Make sure the sensor assembly is installed with the specified torque.
- If the sensor assembly has been dropped, or there are cracks, dents or other detects in the case, bracket or connector, replace the sensor assembly with a new one.
- When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
- After installing, shake the sensor assembly to check that there is no looseness.






2. INSTALL REMOVED PARTS
a. Lower cluster finish panel assembly.
b. Front console box.
c. Rear console box.
d. Heater control.
e. rear end console panel.
f. Upper console panel.
g. Front seat.