Removal and Installation

Front:

REMOVAL
1. REMOVE FRONT WHEEL
Remove the wheel and temporarily fasten the disc with the hub nuts.





2. DISCONNECT FLEXIBLE HOSE
a. Remove the union bolt and 2 gaskets from the caliper, then disconnect the flexible hose from the caliper.
Torque: 29 Nm (300 kgf-cm, 21 ft. lbs.)

HINT: At the time of installation, install the flexible hose lock securely in the lock hole in the caliper.

b. Use a container to catch the brake fluid as it drains out.
3. REMOVE CALIPER
a. Remove the 2 installation bolts.
Torque: 34 Nm (350 kgf-cm, 25 ft. lbs.)
b. Remove the caliper from the torque plate.
4. REMOVE 2 PADS WITH 4 ANTI-SQUEAL SHIMS
5. REMOVE 2 PAD SUPPORT PLATES

NOTICE: At the time of installation, there should be no oil or grease adhering to the friction surfaces of the pads or disc.

INSTALLATION
Installation is in the reverse order of removal.
AFTER INSTALLATION, FILL BRAKE RESERVOIR WITH BRAKE FLUID, BLEED BRAKE SYSTEM AND CHECK FOR LEAKS