Running Board Adjustment

1. Adjust the entire running board assembly to allow the front fascia flap's inner surface to rest on the front cladding fastener mounting surface. Hand start the 10 mm self-tapping mud flap screw through the front running board face. Align the running board to blend with the cladding.

2. Clip together wiring harness connectors. Also, snap vehicle wire harness into top front bracket slot.

3. With a 13 mm socket, torque the 8 mm fasteners of the rear brackets to the following specifications:

Torque: 12 ft lbs (16 Nm)

4. With a 13 mm socket, torque the 8 mm fasteners of the middle brackets.

Torque: 12 ft lbs (16 Nm)

5. With a 13 mm socket, torque the 8 mm fasteners of the front brackets.

Torque: 12 ft lbs (16 Nm)

6. Tighten 10 mm self-tapping screw in front endcap.

7. Adjust front and rear endcap into rocket. Tighten down the 7/16" nuts on all the brackets. Torque the fasteners to the following:

Torque: 8 ft lbs (11 Nm)

8. Reinstall the air conditioning shroud cover over the two air conditioning lines. Use a 10 mm 3/8" drive deep socket (right-hand side only).

9. Reinstall the 20-amp fuse "ECU B1" in the fuse box located under the hood or reconnect the battery cable to the battery.

10. Check running board lights.