Front Seat

DISASSEMBLY




1. REMOVE SEATBACK BOARD
Remove the seatback board as shown in the illustration.

HINT: Remove the seatback board in order "A", "B" as shown in the illustration.

2. REMOVE HEADREST
3. REMOVE SEAT CUSHION OUTER SHIELD
a. Using a screwdriver, remove the power seat switch knobs.

HINT: Tape the screwdriver tip before use.




b. Remove the 4 screws.




c. Disconnect the connectors as shown in the illustration.
d. Remove the seat cushion outer shield.




e. Remove the 3 screws and power seat switch from the seat cushion outer shield.
f. Remove the 2 screws and lumbar support switch from the seat cushion outer shield.

4. REMOVE FRONT SEAT INNER BELT




a. Remove the clamp, then disconnect the connector.
b. Remove the bolts, wave washer and inner belt

Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)




5. REMOVE SEAT CUSHION INNER SHIELD
Remove the 3 screws and seat cushion inner shield.

6. REMOVE SEATBACK ASSEMBLY
a. Disconnect the seat lumbar support connector and seat heater connector.




b. Remove the 4 bolts and seatback assembly.

Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)

7. REMOVE ARMREST

Torque: 37 N.m (375 kgf.cm, 27 ft.lbf)

8. REMOVE SEATBACK FRAME




a. Remove the 2 hog rings.
b. Disengage the hook as shown in the illustration.




c. Remove the 10 hog rings and 2 clamps.
d. Remove the 2 headrest supports.
e. Remove the seatback frame from the seatback cover with pad.




9. REMOVE LUMBAR SUPPORT
Remove the 2 bolts and lumbar support.




10. REMOVE SEATBACK COVER
Remove the 20 hog rings and seatback cover from the seat-back pad.

11. REMOVE SEAT HEATER




12. REMOVE LOWER SEAT CUSHION
Remove the screw and lower seat cushion shield as shown in the illustration.




13. REMOVE FRONT SEAT CUSHION SHIELD
Remove the screw and front seat cushion shield.

14. REMOVE SEAT CUSHION ASSEMBLY




a. Remove the 4 bolts.

Torque: 21 N.m (210 kgf.cm, 15 ft.lbf)

b. Remove the wire harness clamp from the seat cushion assembly.
c. Remove the seat cushion assembly.

15. REMOVE SEAT CUSHION FRAME




a. Remove the wire harness.
b. Disengage the hook.
c. Remove the 5 hog rings and seat cushion frame.

16. REMOVE SEAT CUSHION COVER
17. REMOVE SEAT HEATER
18. REMOVE RECLINING ADJUSTER INSIDE SHIELD




a. Remove the 2 screws and LH reclining adjuster inside shield.
b. Remove the 2 screws and RH reclining adjuster inside shield.

19. REMOVE SEAT POSITION CONTROL RELAY




a. Disconnect the 2 connectors.
b. Remove the 2 bolts and seat position control relay.




20. REMOVE LIFTER MOTOR
Remove the 2 screws and lifter motor.




21. REMOVE FRONT VERTICAL MOTOR
Remove the 2 screws and front vertical motor.




22. REMOVE SLIDING MOTOR
Remove the 2 screws and sliding motor.

23. REMOVE RECLINING MOTOR




a. Using a torx wrench. remove the reclining motor.
b. Remove the 2 screws and reclining motor mounting bracket from the reclining motor.

REASSEMBLY
Reassembly is in the reverse order of disassembly.