Power Window Motor: Testing and Inspection

Driver's door and rear right door: INSPECT POWER WINDOW MOTOR OPERATION




a. Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 4, check that the motor turns counterclockwise.




b. Reverse the polarity, check that the motor turns clockwise.
If operation is not as specified, replace the motor.

Passenger's door and rear left door: INSPECT POWER WINDOW MOTOR OPERATION




a. Connect the positive (+) lead from the battery to terminal 4 and the negative (-) lead to terminal 1, check that the motor turns clockwise.




b. Reverse the polarity, check that the motor turns counterclockwise.
If operation is not as specified, replace the motor.

Driver's Door: INSPECT POWER WINDOW MOTOR PTC OPERATION




a. Disconnect the connector from the master switch.
b. Connect the positive (+) lead from the battery to terminal 20 and the negative (-) lead to terminal 8 on the wire harness side connector and raise the window to full closed position.
c. Continue to apply voltage, check that there is a PTC operation noise within approximately 4 to 90 seconds.




d. Reverse the polarity, check that the window begins to descend within approximately 60 seconds.
If operation is not as specified, replace the motor.

Front Passenger's Door: INSPECT POWER WINDOW MOTOR PTC OPERATION




a. Disconnect the connector from the power window switch.
b. Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 6 on the wire harness side connector, and raise the window to full closed position.
c. Continue to apply voltage, check that there is a PTC operation noise within approximately 4 to 90 seconds.




d. Reverse the polarity, check that the window begins to descend within approximately 60 seconds.
If operation is not as specified, replace the motor.

Left side: INSPECT POWER VENT WINDOW MOTOR OPERATION




a. Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 2, and check that the window link moves to OPEN position.




b. Remove the polarity and check that the window link moves to CLOSE position.
If operation is not as specified, replace the window motor.

Right side: INSPECT POWER VENT WINDOW MOTOR OPERATION




a. Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1, and check that the window link moves to OPEN position.




b. Remove the polarity and check that the window link moves to CLOSE position.