Television Camera ECU
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE REAR DOOR SCUFF PLATE RH
3. REMOVE DECK BOARD SUB-ASSEMBLY
4. REMOVE TONNEAU COVER ASSEMBLY
5. REMOVE DECK FLOOR BOX FRONT
6. REMOVE DECK FLOOR BOX REAR
7. REMOVE NO.2 DECK BOARD SUB-ASSEMBLY
8. REMOVE NO.3 DECK BOARD SUB-ASSEMBLY
9. REMOVE BACK DOOR WEATHERSTRIP
10. REMOVE JACK CARRIER SUPPORT
11. REMOVE JACK ASSEMBLY
12. REMOVE JACK CARRIER ASSEMBLY
13. REMOVE DECK SIDE TRIM BOX LH
14. REMOVE DECK SIDE TRIM BOX RH
15. REMOVE REAR FLOOR FINISH PLATE
16. REMOVE REAR FLOOR FINISH SIDE PLATE RH
17. REMOVE DECK SIDE TRIM COVER RH
18. SEPARATE REAR NO.1 SEAT BELT ASSEMBLY OUTER RH
19. REMOVE REAR SEAT SIDE COVER RH
20. REMOVE ROPE HOOK
21. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
22. REMOVE NO.2 ROOM LIGHT ASSEMBLY
23. REMOVE NO.1 TONNEAU COVER HOLDER CAP
24. ROOF SIDE GARNISH ASSEMBLY INNER RH
25. REMOVE TELEVISION CAMERA ECU
a. Disconnect the 3 connectors.
b. Remove the 3 bolts and the television camera ECU.
INSTALLATION
1. INSTALL TELEVISION CAMERA ECU
a. Install the television camera with the 3 bolts.
b. Connect the 3 connectors.
2. INSTALL ROOF SIDE GARNISH ASSEMBLY INNER RH
3. INSTALL NO.1 TONNEAU COVER HOLDER CAP
4. INSTALL NO.2 ROOM LIGHT ASSEMBLY
5. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH
6. INSTALL ROPE HOOK
7. INSTALL REAR SEAT SIDE COVER RH
8. INSTALL REAR NO.1 SEAT BELT ASSEMBLY OUTER RH
9. INSTALL DECK SIDE TRIM COVER RH
10. INSTALL REAR FLOOR FINISH SIDE PLATE RH
11. INSTALL REAR FLOOR FINISH PLATE
12. INSTALL DECK SIDE TRIM BOX LH
13. INSTALL DECK SIDE TRIM BOX RH
14. INSTALL JACK CARRIER ASSEMBLY
15. INSTALL JACK ASSEMBLY
16. INSTALL JACK CARRIER SUPPORT
17. INSTALL BACK DOOR WEATHERSTRIP
18. INSTALL NO.3 DECK BOARD SUB-ASSEMBLY
19. INSTALL NO.2 DECK BOARD SUB-ASSEMBLY
20. INSTALL DECK FLOOR BOX REAR
21. INSTALL DECK FLOOR BOX FRONT
22. INSTALL TONNEAU COVER ASSEMBLY
23. INSTALL DECK BOARD SUB-ASSEMBLY
24. INSTALL REAR DOOR SCUFF PLATE RH
25. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
26. PERFORM INITIALIZATION
NOTE: Some systems need initialization when disconnecting the cable from negative battery terminal.