Navigation Module: Service and Repair
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE DECK BOARD SUB-ASSEMBLY
3. REMOVE TONNEAU COVER ASSEMBLY
4. REMOVE JACK CARRIER SUPPORT
5. REMOVE JACK ASSEMBLY
6. REMOVE JACK CARRIER ASSEMBLY
7. REMOVE DECK FLOOR BOX FRONT
8. REMOVE DECK FLOOR BOX REAR
9. REMOVE DECK NO.2 BOARD SUB-ASSEMBLY
10. REMOVE DECK NO.3 BOARD SUB-ASSEMBLE
11. REMOVE REAR FLOOR FINISH PLATE
12. REMOVE DECK SIDE TRIM LH BOX
13. REMOVE DECK SIDE TRIM RH BOX
14. REMOVE NAVIGATION ECU
a. Disengage the clamp and disconnect the 3 connectors.
b. Remove the 3 bolts and the navigation ECU.
15. REMOVE DISC PLAYER BRACKET
a. Remove the screw and the disc player bracket.
16. REMOVE NO.2 DISC PLAYER BRACKET
a. Remove the 2 screws and the No.2 disc player bracket.
INSTALLATION
1. INSTALL NO.2 DISC PLAYER BRACKET
a. Install the No.2 disc player bracket with the 2 screws.
2. INSTALL DISC PLAYER BRACKET
a. Install the disc player bracket with the screw.
3. INSTALL NAVIGATION ECU
a. Install the navigation ECU with the 3 bolts.
b. Connect the 3 connectors and engage the clamp.
4. INSTALL DECK SIDE TRIM LH BOX
5. INSTALL DECK SIDE TRIM RH BOX
6. INSTALL REAR FLOOR FINISH PLATE
7. INSTALL DECK NO.3 BOARD SUB-ASSEMBLY
8. INSTALL DECK NO.2 BOARD SUB-ASSEMBLY
9. INSTALL DECK FLOOR BOX REAR
10. INSTALL DECK FLOOR BOX FRONT
11. INSTALL JACK CARRIER ASSEMBLY
12. INSTALL JACK ASSEMBLY
13. INSTALL JACK CARRIER SUPPORT
14. INSTALL TONNEAU COVER ASSEMBLY
15. INSTALL DECK BOARD SUB-ASSEMBLY
16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
17. PERFORM INITIALIZATION Programming and Relearning
NOTE: Some systems need initialization when disconnecting the cable from negative battery terminal.