Removal and Replacement
REMOVAL1. REMOVE REAR FLOOR FINISH PLATE
a. Remove the 2 clips (A).
b. Using a screwdriver, disengage the 2 claws, 6 clips (B) and remove the finish plate.
HINT: Tape the screwdriver tip before use.
2. REMOVE DECK FLOOR BOX REAR.
3. REMOVE DECK SIDE TRIM BOX.
4. REMOVE REAR BUMPER SIDE SEAL
a. Remove the clip, nut, bolt and side seal.
5. REMOVE FUEL TANK FILLER PIPE PROTECTOR
a. Remove the 2 clips, bolt and protector.
6. REMOVE REAR BUMPER COVER
a. Put protective tape under the quarter panel.
b. Remove the 2 clips and nuts.
c. With Air suspension system:
Remove the 6 screws.
d. Without Air suspension system:
Remove the 4 screws.
e. Using a screwdriver, disengage the 10 claws and remove the bumper cover.
HINT: Tape the screwdriver tip before use.
INSTALLATION
1. INSTALL REAR BUMPER COVER
a. Engage the 10 claws and install the bumper cover.
b. With Air suspension system:
Install the 6 screws.
c. Without Air suspension system:
Install the 4 screws.
d. Install the 2 clips and 4 nuts.
2. INSTALL FUEL TANK FILLER PIPE PROTECTOR
3. INSTALL REAR BUMPER SIDE SEAL
4. INSTALL DECK SIDE TRIM BOX
5. INSTALL DECK FLOOR BOX REAR
6. INSTALL REAR FLOOR FINISH PLATE