Sliding Roof System (For Standard)

INITIALIZATION

1. RESET SLIDING ROOF MOTOR
a. The sliding roof may not operate automatically and the jam protection function will not function correctly after you reconnect, replace or recharge the battery. In any of these cases, reset the sliding roof system using the following method.
1. Push and hold the slide switch toward the front or tilt switch on the rear side.
2. Check that the sliding roof will tilt up and down, or slide open and close.
3. After the slide operation, release the switch.
4. Make sure that the sliding roof opens and closes automatically.

HINT: If the battery terminal is disconnected, the ECU of the sliding roof motor may not detect the position of the roof glass. If the AUTO operation function is still disabled even after the sliding roof motor is reset, the hall IC (built in the sliding roof motor assembly) for detecting the roof glass position may be malfunctioning.