Removal and Installation
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE FRONT DOOR SCUFF PLATE RH
3. REMOVE COWL SIDE TRIM RH SUB-ASSEMBLY
4. REMOVE INSTRUMENT PANEL UNDER COVER NO.2 SUB-ASSEMBLY
5. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
6. REMOVE AIR DUCT NO.2
a. Remove the screw.
b. Release the 2 claws and remove the air duct No. 2.
7. DISCONNECT WIRING AIR INDICATOR HARNESS NO.2 SUB-ASSEMBLY
a. Remove the clamp and disconnect the 2 connectors.
8. REMOVE BLOWER ASSEMBLY
a. Remove the clamp and disconnect the connectors.
b. Remove the 4 screws and the nut, and then the bracket.
c. Remove the bolt and 2 screws.
d. Release the claw and remove the blower assembly.
INSTALLATION
1. INSTALL BLOWER ASSEMBLY
a. Install the blower assembly with the claw.
b. Install the bolt and 2 screws.
Torque: BOLT 9.8 N.m (100 kgf.cm, 87 in.lbf)
c. Install the bracket with the 4 screws and nut.
Torque: NUT 9.8 N.m (100 kgf.cm, 87 in.lbf)
d. Install the clamp and connect the connectors.
2. INSTALL WIRING AIR INDICATOR HARNESS NO.2 SUB-ASSEMBLY
3. INSTALL AIR DUCT NO.2
a. Install the air duct No. 2 with the screw.
Torque: 2.5 N.m (25 kgf.cm, 22 in.lbf)
4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
5. INSTALL INSTRUMENT PANEL UNDER COVER NO.2 SUB-ASSEMBLY
6. INSTALL COWL SIDE TRIM RH SUB-ASSEMBLY
7. INSTALL FRONT DOOR SCUFF PLATE RH
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9. PERFORM INITIALIZATION
NOTE: Some systems need initialization when disconnecting the cable from the negative battery terminal.