Front Speed Sensor

FRONT SPEED SENSOR

COMPONENTS:

REMOVAL

HINT: Replace the RH side by using the same procedures as those as those for the LH side.

1. REMOVE FRONT WHEEL
2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
3. REMOVE SPEED SENSOR FRONT LH
a. Disconnect the speed sensor connector.





b. Remove the 2 bolts and the clamp from the body and the shock absorber assembly.





c. Remove the bolt and the speed sensor front.

NOTICE: Prevent foreign matter from attaching to the sensor tip.

INSPECTION
1. INSPECT FRONT SPEED SENSOR
a. Make sure that there is no looseness at the connectors' locking part and connecting part of connector.
b. Disconnect the speed sensor connector.





c. Measure the resistance according to the value(s) in the table.

Resistance LH:

Resistance RH:

d. Measure the resistance according to the value(s) in the table.

Resistance LH:

Resistance RH:

NOTICE: Check the speed sensor signal after replacement.

INSTALLATION
1. INSTALL SPEED SENSOR FRONT LH





a. Install the speed sensor front with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)

NOTICE: Prevent foreign matter from attaching to the sensor tip.





b. Install the speed sensor front with the 2 bolts and the clamp.
Torque:
Bolt A 5.0 Nm (51 kgf-cm, 44 inch lbs.)
Bolt B 29 Nm (296 kgf-cm, 21 ft. lbs.)

NOTICE: Do not twist the sensor wire when installing the sensor.

c. Connect the speed sensor connector.
2. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
3. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
4. CHECK ABS SPEED SENSOR SIGNAL