Disassembly and Reassembly

DISASSEMBLY

1. REMOVE REPAIR SERVICE STARTER KIT




a. Remove the nut, and disconnect the lead wire from the repair service starter kit.




b. Remove the 2 screws which are used to secure the repair service starter kit to the starter drive housing.
c. Remove the repair service starter kit.
d. Remove the return spring and plunger from the motor terminal starter kit.

2. REMOVE STARTER YOKE ASSEMBLY




a. Remove the 2 through bolts, and pull out the starter yoke together with the starter commutator end frame.




b. Remove the starter yoke from the starter commutator end frame.




3. REMOVE STARTER ARMATURE PLATE
a. Remove the starter armature plate from the starter yoke.




4. REMOVE STARTER COMMUTATOR END FRAME COVER
a. Using a screwdriver, remove the starter commutator end frame cover.




5. REMOVE STARTER ARMATURE ASSEMBLY
a. Using snap ring pliers, remove the snap ring and the plate washer.
b. Remove the starter armature from the commutator end frame.




6. REMOVE PLANET GEAR
a. Remove the 3 planet gears from the motor terminal starter kit.

REASSEMBLY




1. INSTALL PLANET GEAR
a. Apply grease to the planet gears and pin parts of the planetary shaft.
b. Install the 3 planet gears.

2. INSTALL STARTER ARMATURE ASSEMBLY




a. Apply grease to the plate washer and the armature shaft.
b. Install the starter armature to the starter commutator end frame.
c. Using snap ring pliers, install the plate washer and a new snap ring.




d. Using vernier calipers, measure the snap ring.

Maximum length: 5.0 mm (0.197 in.)

If the length is greater than maximum, replace it with a new snap ring.




3. INSTALL STARTER COMMUTATOR END FRAME COVER
a. Install the starter commutator end frame cover to the starter commutator end frame.




4. INSTALL STARTER ARMATURE PLATE
a. Insert the starter armature plate to the starter yoke.
b. Align the keyway of the starter plate with the key inside the starter yoke, and install the starter plate.




5. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY
a. Align the rubber with the convex cutout of starter yoke.
b. Install starter commutator end frame to the starter yoke.

6. INSTALL STARTER YOKE ASSEMBLY




a. Align the key of the starter yoke with the keyway of starter drive housing.




b. Install the starter yoke with the 2 through bolts.

Torque: 6.0 N.m (61 kgf.cm, 53 in.lbf)

7. INSTALL REPAIR SERVICE STARTER KIT




a. Apply grease to the plunger and the hook.
b. Hang the plunger hook of the repair service starter kit to the drive lever.
c. Install the plunger and the return spring.




d. Install repair service starter kit with the 2 screws.

Torque: 7.5 N.m (76 kgf.cm, 66 in.lbf)




e. Connect the lead wire to the repair service starter kit with the nut.

Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)