Bearing Retainer Oil Seal
BEARING RETAINER OIL SEALComponents:
REMOVAL
1. DRAIN AUTOMATIC TRANSAXLE FLUID
a. Remove the automatic drain plug, gasket and bleed the drain automatic transaxle fluid.
2. REMOVE NO. 1 TRANSFER CASE PLUG
3. REMOVE TRANSFER DRAIN PLUG
a. Remove the transfer drain plug, gasket and bleed the drain transfer oil.
4. REMOVE FRONT WHEEL
5. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
6. REMOVE TRANSFER RH BEARING RETAINER OIL SEAL
a. Using SST(s), remove the transfer RH bearing retainer oil seal.
SST 09308-00010
NOTICE: Do not damage the oil-seal-fitted surface of the case.
INSTALLATION
1. INSTALL TRANSFER RH BEARING RETAINER OIL SEAL
SST 09223-46011
a. Using SST(s), install a new transfer RH bearing retainer oil seal to the transfer case at the position as show in the illustration.
NOTICE: Do not install the oil seal obliquely.
b. Apply small amount of MP grease to the oil seal lip.
2. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
3. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
4. ADD AUTOMATIC TRANSAXLE FLUID
5. INSTALL TRANSFER DRAIN PLUG
a. Install the transfer drain plug with a new drain gasket.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
6. INSTALL NO. 1 TRANSFER CASE PLUG
a. Add oil up 0 to 5 mm (0 to 0.20 inch) below the lower side of the plug hole.
Oil amount: 0.9 L (0.95 US qts, 0.71 Imp.qts.)
HINT: When adding oil, pour it slowly
b. Install the No. 1 transfer case plug with a new No. 1 gasket.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
7. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
8. CHECK ABS SPEED SENSOR SIGNAL