Extension Housing Oil Seal
EXTENSION HOUSING OIL SEALComponents:
REMOVAL
1. REMOVE TRANSFER CASE NO.1 PLUG
2. REMOVE TRANSFER DRAIN PLUG
a. Remove the transfer drain plug, drain gasket and bleed transfer oil.
3. REMOVE EXHAUST PIPE ASSEMBLY
4. REMOVE PROPELLER W/CENTER BEARING SHAFT ASSEMBLY
5. REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL
a. Using SST(s), remove the transfer extension housing type T oil seal from the transfer extension housing sub- assembly.
SST 09308-00010
NOTICE: Be careful not to damage the oil-seal-fitted surface and the inside surface of the bush.
INSTALLATION
1. INSTALL TRANSFER EXTENSION HOUSING TYPE T OIL SEAL
a. Using SST(s), install a new transfer extension housing type T oil seal to the transfer extension housing sub-assembly at the position show in the illustration.
SST 09325-20010
NOTICE: Do not install the oil seal obliquely.
b. Apply small amount of MP grease to the oil seal lip.
2. TEMPORARILY TIGHTEN PROPELLER W/CENTER BEARING SHAFT ASSEMBLY
3. FULLY TIGHTEN PROPELLER W/CENTER BEARING SHAFT ASSEMBLY
4. INSTALL EXHAUST PIPE ASSEMBLY
5. CHECK FOR EXHAUST GAS LEAKAGE
6. INSTALL TRANSFER DRAIN PLUG
a. Install the transfer drain plug with a new drain gasket.
Torque: 49 Nm (50 kgf-cm, 36 ft. lbs.)
7. INSTALL TRANSFER CASE NO.1 PLUG
a. Add oil up to 0 to 5 mm (0 to 0.20 inch) below the lower side of the plug hole.
Oil amount: 0.9 L (0.95 US qts, 0.71 Imp.qts.)
NOTICE: When supplying oil, pour do it slowly.
b. Install the transfer case No. 1 plug with a new gasket No. 1.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)