Auxiliary Input / Output Jack: Service and Repair
VIDEO TERMINALREMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE REAR DOOR SCUFF PLATE RH
3. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
4. REMOVE DECK BOARD SUB-ASSEMBLY
5. REMOVE TONNEAU COVER ASSEMBLY
6. REMOVE JACK CARRIER SUPPORT
7. REMOVE JACK ASSEMBLY
8. REMOVE JACK CARRIER ASSEMBLY
9. REMOVE DECK FLOOR BOX FRONT
10. REMOVE DECK FLOOR BOX REAR
11. REMOVE DECK NO.2 BOARD SUB-ASSEMBLY
12. REMOVE DECK NO.3 BOARD SUB-ASSEMBLY
13. REMOVE BACK DOOR WEATHERSTRIP
14. REMOVE DECK SIDE TRIM BOX LH
15. REMOVE DECK SIDE TRIM BOX RH
16. REMOVE DECK SIDE TRIM COVER RH
17. REMOVE REAR FLOOR FINISH PLATE
18. REMOVE REAR FLOOR FINISH SIDE PLATE RH
19. SEPARATE REAR NO.1 SEAT BELT ASSEMBLY OUTER RH
20. REMOVE REAR SEAT SIDE COVER RH
21. REMOVE ROPE HOOK
22. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
23. REMOVE NO.2 ROOM LIGHT ASSEMBLY
24. REMOVE NO.1 TONNEAU COVER HOLDER CAP
25. REMOVE ROOF SIDE GARNISH ASSEMBLY INNER RH
26. REMOVE VIDEO TERMINAL
a. Disengage the 4 claws and remove the video terminal.
INSTALLATION
1. INSTALL VIDEO TERMINAL
a. Engage the 4 claws and install the video terminal.
2. INSTALL ROOF SIDE GARNISH ASSEMBLY INNER RH
3. INSTALL NO.1 TONNEAU COVER HOLDER CAP
4. INSTALL NO.2 ROOM LIGHT ASSEMBLY
5. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH
6. INSTALL ROPE HOOK
7. INSTALL REAR SEAT SIDE COVER RH
8. INSTALL REAR NO.1 SEAT BELT ASSEMBLY OUTER RH
9. INSTALL REAR FLOOR FINISH SIDE PLATE RH
10. INSTALL REAR FLOOR FINISH PLATE
11. INSTALL DECK SIDE TRIM COVER RH
12. INSTALL DECK SIDE TRIM BOX LH
13. INSTALL DECK SIDE TRIM BOX RH
14. INSTALL BACK DOOR WEATHERSTRIP
15. INSTALL DECK NO.3 BOARD SUB-ASSEMBLY
16. INSTALL DECK NO.2 BOARD SUB-ASSEMBLY
17. INSTALL DECK FLOOR BOX REAR
18. INSTALL DECK FLOOR BOX FRONT
19. INSTALL JACK CARRIER ASSEMBLY
20. INSTALL JACK ASSEMBLY
21. INSTALL JACK CARRIER SUPPORT
22. INSTALL TONNEAU COVER ASSEMBLY
23. INSTALL DECK BOARD SUB-ASSEMBLY
24. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH
25. INSTALL REAR DOOR SCUFF PLATE RH
26. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
27. PERFORM INITIALIZATION
NOTE: Some systems need initialization when disconnecting the cable from negative battery terminal.