Fluid - Transfer Case: Service and Repair
TRANSFER OILADJUSTMENT
1. INSPECT TRANSFER OIL
(a) Remove the case plug No. 1 (filler plug) and gasket.
(b) Check that the oil level is within 5 mm (0.20 in.) of the bottom of the case plug No. 1 (filler plug) hole.
NOTICE:
^ When replacing the oil, recheck the oil level after driving.
^ Excessively large or small quantities of oil may cause troubles.
(c) When the oil level is too low, check for oil leakage.
(d) Tighten the case plug No. 1 (filler plug) with a new gasket.
Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf)
2. ADJUST TRANSFER OIL
(a) Remove the case plug No. 1 (filler plug) and gasket then supply oil.
NOTICE:
^ When supplying oil, pour slowly.
^ Pour the oil in several stages allowing several minutes between each step.
HINT: The oil level should be within 5 mm (0.20 in.) of the bottom of the oil filler plug hole.
(b) After leaving it alone for 5 minutes, check the oil level again.
(c) Tighten the case plug No. 1 (filler plug) with a new gasket.
Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf)