Camshaft Position Sensor: Service and Repair

REMOVAL

1. DRAIN ENGINE COOLANT
2. REMOVE V-BANK COVER SUB-ASSEMBLY
3. REMOVE FAN AND GENERATOR V BELT
4. REMOVE OIL COOLER PIPE
5. REMOVE TIMING BELT COVER SUB-ASSEMBLY NO. 3 LH




6. REMOVE CAMSHAFT POSITION SENSOR
a. Disconnect the camshaft position sensor connector.
b. Remove the bolt, stud bolt and camshaft position sensor.

INSTALLATION




1. INSTALL CAMSHAFT POSITION SENSOR
a. Install the camshaft position sensor with the bolt and stud bolt.

Torque: 7.5 N.m (80 kgf.cm, 66 in.lbf)

b. Reconnect the camshaft position sensor connector.

2. INSTALL TIMING BELT COVER SUB-ASSEMBLY NO. 3 LH
3. INSTALL OIL COOLER PIPE
4. INSTALL FAN AND GENERATOR V BELT
5. ADD ENGINE COOLANT
6. CHECK FOR ENGINE COOLANT LEAKS
7. INSTALL V-BANK COVER SUB-ASSEMBLY