On-Vehicle Inspection

POWER MIRROR CONTROL SYSTEM (w/ Memory)

ON-VEHICLE INSPECTION





1. CHECK MEMORY AND REACTIVATION FUNCTION
a. Turn the ignition switch ON and move the shift lever into the P position.
b. Move the seat into the foremost position and uppermost position using each seat switch.
c. Check that the buzzer sounds for 0.5 second and the seat position is recorded when the M1 switch is pressed while the SET switch is held down.
d. Move the seat out of the foremost position and uppermost position using each seat switch.
e. Check that the buzzer sounds for 0.5 second and the seat position is recorded when the M2 switch is pressed while the SET switch is held down.
f. Check that the buzzer sounds for 0.1 second and the seat automatically moves into the foremost position and uppermost position (set positions) when the M1 switch is pressed.
g. Check that the buzzer sounds for 0.1 second and the seat automatically moves out of the foremost position and uppermost position (set positions) when the M2 switch is pressed.
h. Check that the seat automatically moves into the set position when the M1 or M2 switch is pressed within 30 seconds after the ignition switch is turned OFF, the key is pulled out from the key cylinder and the driver side door is opened.
i. Move the seat into the maximum positions of the slide movement, and disconnect the negative terminal of the battery while the memory switch is in the ON position. Then leave the seat in the position for 3 minutes. The seat position memory will be erased.
j. Move the seat into all the maximum positions (front/ rear and up/down) using each seat switch.
k. Check that the seat does not move (the seat position is not recorded) when the M1 switch or the M2 switch is pressed, after the M1 switch and M2 switch are pressed at one time while the SET switch is held down.